Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Multiphase Science and Technology
SJR: 0.124 SNIP: 0.222 CiteScore™: 0.26

ISSN Imprimir: 0276-1459
ISSN On-line: 1943-6181

Multiphase Science and Technology

DOI: 10.1615/MultScienTechn.v12.i3-4.160
19 pages

A STUDY OF DRYOUT IN ANNULAR FLOW OF SINGLE COMPONENT HYDROCARBONS AND THEIR MIXTURES

Jader R. Barbosa, Jr.
Polo Research Laboratories for Emerging Technologies in Cooling and Thermophysics, Federal University of Santa Catarina 88040-900, Trindade, Florianópolis, SC, Brazil
T. Kandlbinder
Department of Chemical Engineering and Chemical Technology, Imperial College of Science, Technology and Medicine, London, SW7 2BY
Geoffrey F. Hewitt
Department of Chemical Engineering, Imperial College London, London SW7 2AZ, UK

RESUMO

Experimental and modelling results on critical heat flux in upward flow in round tubes are presented. The data were collected at a high pressure boiling facility using single component hydrocarbons (pentane and iso-octane), binary and ternary hydrocarbon mixtures (pentane/iso-octane and pentane/hexane/iso-octane). The system pressure ranged from 2 to 11 bar, the total mass fluxes from 100 to 550 kg/m2s and the wall heat flux from 30 to 100 kW/m2. The 8.68 m long vertical test section is made of 321 stainless steel. The inner and outer diameters are 25.4 and 38.0 mm, respectively. When the results are compared with predictions from an annular flow modelling code, an over-prediction (i.e., non-conservative) of the dryout quality for both single component and multicomponent cases is observed. Reasons for such discrepancies are explored and corrections to the calculation methodology are proposed in the context of droplet entrainment and deposition calculations.


Articles with similar content:

A STUDY OF DRYOUT IN ANNULAR FLOW OF SINGLE COMPONENT HYDROCARBONS AND THEIR MIXTURES
Boiling 2000 Phenomena and Emerging Applications Volume 2, Vol.1, 2000, issue
T. Kandlbinder, Geoffrey F. Hewitt, J. R. Barbosa
POST-DRYOUT HEAT TRANSFER FOR STEAM/WATER FLOWING IN VERTICAL TUBES AT HIGH PRESSURE
International Heat Transfer Conference 7, Vol.9, 1982, issue
B. Scruton, B. Chojnowski
BOILING ON A HORIZONTAL PLAIN TUBE BUNDLE WITH AMMONIA/LUBRICANT MIXTURE SUBJECTED TO INLET VAPOR QUALITY
International Heat Transfer Conference 13, Vol.0, 2006, issue
Ming-Chien Chyu, J. X. Zheng, Zahid Ayub
FLOW BOILING MEASUREMENTS ON PENTANE, ISO-OCTANE AND PENTANEASO-OCTANE MIXTURES
International Heat Transfer Conference 10, Vol.20, 1994, issue
V.V. Wadekar, G. Costigan, D.P. Frankum
DISTRIBUTION OF LIQUID AND FORMED VAPOUR IN UNHEATED AND HEATED TUBE WITH A HIGH VELOCITY AIR FLOW
International Heat Transfer Conference 9, Vol.6, 1990, issue
A.D. Rekin