Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Atomization and Sprays
Fator do impacto: 1.262 FI de cinco anos: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Imprimir: 1044-5110
ISSN On-line: 1936-2684

Volumes:
Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.v19.i11.20
pages 1013-1029

GAS ENTRAINMENT CHARACTERISTICS OF DIESEL SPRAY DURING END OF INJECTION TRANSIENT

Seoksu Moon
Department of Mechanical Engineering, Inha University
Keiya Nishida
Department of Mechanical System Engineering, University of Hiroshima, 1-4-1 Kagamiyama, Higashi-Hiroshima, Hiroshima 739-8527, Japan
Yuhei Matsumoto
Department of Mechanical System Engineering, University of Hiroshima, 1-4-1 Kagamiyama, Higashi-Hiroshima 739-8527, Japan
Jeekuen Lee
Faculty of Precision Mechanical Engineering, 664-14, 1-ga, Duckjin-dong, Duckjin-gu, Jeonju, Chonbuk, 561-756, Republic of Korea

RESUMO

This paper reports the effect of injection parameters such as nozzle hole diameter and injection duration on gas entrainment of diesel sprays during the end of injection transient. The entrained gas flow fields of transient diesel sprays were measured using particle image velocimetry incorporated with the laser-induced fluorescence technique. To investigate the effect of injection parameters, two nozzles with different hole diameters and two injection modes (a quasi-steady injection with long injection duration and a transient injection with short injection duration) were applied. In all test cases, in order to compensate for the decreased mass inside the spray caused by the decrease in fuel supply, gas entrainment during the end of injection transient increased compared to that of the quasi-steady state. In the case of the nozzle with a larger hole diameter, the steeper decrease in fuel mass flow rate during the end of injection transient resulted in a higher rate of entrained gas flow compared to that of the nozzle with the smaller nozzle hole diameter. However, this increasing rate of gas flow rate appears similar regardless of applied injection modes, a quasi-steady injection with long injection duration and a transient injection with short injection duration, supposedly due to the similar decreasing rate of fuel mass flow during the end of injection transient. The decrease in mass inside the spray (mass disturbance) propagated from the nozzle tip region to downstream with time. This propagation speed of mass disturbance inside the spray was affected by the penetrating rate of the spray during injection, and increased through the nozzle with a larger hole diameter and quasi-steady injection with longer injection duration.


Articles with similar content:

EXPERIMENTAL INVESTIGATION OF SPRAY CHARACTERISTICS OF DIESEL-METHANOL-WATER EMULSION
Atomization and Sprays, Vol.25, 2015, issue 8
Wuqiang Wang, Shenteng Cao, Dongyin Wu, Junjie Yan, Zhenzhou Pang
SPRAY STRUCTURE FROM DOUBLE FUEL INJECTION IN MULTIHOLE INJECTORS FOR GASOLINE DIRECT-INJECTION ENGINES
Atomization and Sprays, Vol.19, 2009, issue 6
Nicholas Mitroglou, J. M. Nouri, C. Arcoumanis
EFFECT OF INJECTION PARAMETERS ON SPRAY CHARACTERISTICS OF GAS-TO-LIQUID (GTL), BIODIESEL, AND DIESEL FUEL FOR A MULTI-HOLE INJECTOR IN A DIESEL ENGINE
Atomization and Sprays, Vol.25, 2015, issue 12
Chang Sik Lee, Donggon Lee, Hyun Gu Roh, Kibong Choi
QUANTITATIVE MEASUREMENTS OF DIESEL FUEL SPRAY CHARACTERISTICS IN THE NEAR-NOZZLE REGION USING X-RAY ABSORPTION
Atomization and Sprays, Vol.11, 2001, issue 4
Johannes K. Schaller, Jinn-Chyi Wang, Christopher F. Powell, Ramesh Poola, Yong Yue
EFFECT OF SPLIT INJECTION ON THE MACROSCOPIC DEVELOPMENT AND ATOMIZATION CHARACTERISTICS OF A DIESEL SPRAY INJECTED THROUGH A COMMON-RAIL SYSTEM
Atomization and Sprays, Vol.16, 2006, issue 5
Rolf D. Reitz, Chang Sik Lee, Sungwook Park