Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Atomization and Sprays
Fator do impacto: 1.737 FI de cinco anos: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 2.2

ISSN Imprimir: 1044-5110
ISSN On-line: 1936-2684

Volumes:
Volume 30, 2020 Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2013008442
pages 349-366

DROP DEFORMATION AND ACCELERATION: THE EFFECTS OF INERTIA IN FRAGMENTATION

Oleksandr G. Girin
Odesa National Maritime University, Mechnikova Str. 34, Odesa, 65029, Ukraine

RESUMO

This paper theoretically investigates the dynamics of internal drop motion and presents significant conclusions with respect to the role of deformational flow in drop fragmentation at low Weber numbers. The influence of deformational flow results in a selection mechanism between "bag", "claviform", and "multimode" breakup modes. This paper and conclusions are based on both the formulated instability necessary conditions and an advanced mathematical model of an accelerating and deforming drop. The analysis takes into account the pressure and surface tension force distributions along an ellipsoidal drop surface as well as the increasing gas velocity at a drop equator, caused by the flattening. It is suggested that the gas velocity values along an ellipsoid surface are the same as for a sphere at points where the angles between the normal vector to drop surface and the stream direction are the same. The numerical solutions of derived equations are used in analyzing the mass force field formation inside an accelerating and deforming drop and two stages of this process are established. It is shown that the distortion of the inertial force field, caused by deformation, causes the selection between breakup modes This paper concludes that during the first stage the deformational flow prevails over the drop's aerodynamic entrainment. Thus, the transiency and nonuniformity of the inertial force field, which are caused by the deformation, prevent "bag" early formation and result in either a "claviform" or a "multimode" mode at the later stage.


Articles with similar content:

ON THE MECHANISM OF INVISCID DROP BREAKUP AT RELATIVELY SMALL WEBER NUMBERS
Atomization and Sprays, Vol.22, 2012, issue 11
Oleksandr G. Girin
Stochastic Dynamics of Oscillator Drift in Media with Spatially Nonhomogeneous Friction
Journal of Automation and Information Sciences, Vol.40, 2008, issue 7
Vladimir A. Dobrynskiy, Mikhail A. Ivanov
TWIN-FLUID ATOMIZATION: FACTORS INFLUENCING MEAN DROP SIZE
Atomization and Sprays, Vol.2, 1992, issue 2
Arthur H. Lefebvre
ON THE DISINTEGRATION OF FAN-SHAPED LIQUID SHEETS
Atomization and Sprays, Vol.22, 2012, issue 9
Juan Carlos Ramos, Alejandro Rivas, R. Anton, Mireia Altimira
GROWTH OF LONGITUDINAL WAVES IN PLANE LIQUID SHEETS HAVING LATERAL WAVE MODES WHEN EXPOSED TO TWO GAS STREAMS OF UNEQUAL VELOCITIES
Atomization and Sprays, Vol.15, 2005, issue 2
T. John Tharakan, K. Ramamurthi