Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Atomization and Sprays
Fator do impacto: 1.737 FI de cinco anos: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 2.2

ISSN Imprimir: 1044-5110
ISSN On-line: 1936-2684

Volumes:
Volume 30, 2020 Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2015013223
pages 585-605

THE EFFECTS OF GAS LAYER AND LIQUID PHYSICAL PROPERTIES ON THE BREAKUP OF COAXIAL LIQUID JET SPRAY

Tony Yuan
Department of Aeronautics and Astronautics, National Cheng Kung University, Tainan, Taiwan, ROC
Marx Tang
Department of Aeronautics and Astronautics, National Cheng Kung University, Tainan, Taiwan, ROC

RESUMO

A coaxial injector is mainly used in large-scale liquid rocket engines. By utilizing optical methods, this research studies the effects of the gas to liquid velocity ratio (2.9−60), gas layer thickness (1.2−2.4 mm), and liquid physical properties (surface tension and viscosity) on the breakup and atomization of coaxial liquid jet spray. The spray angles, droplet size distributions, and breakup processes at different experimental conditions are observed and analyzed. The results reveal the significance of the breakup of the coaxial jet spray as the surrounding high-speed air confines the spray spatially and forces the inherent unstable liquid column into spiral-type turning, then elongates into a ligament before instantaneous breakup. Once the liquid jet has broken up, the outer high-speed air appears to have no further effect on the spray. Owing to this controlling breakup process, the spray angle appears to be increased with increasing velocity ratio and decreased with increasing gas layer thickness, and the droplet size distribution of coaxial jet spray appears to be uniform, concentrated, and invariant after the jet has broken up. Liquid viscosity shows a strong effect on coaxial jet spray. With higher viscosity, the liquid ligament is stretched wider before disintegration; that is, the liquid ligament may utilize more energy of the surrounding high-speed air for liquid atomization, thus producing a larger spray angle and smaller droplet sizes, as observed in the experiments.


Articles with similar content:

PULSATING SLURRY ATOMIZATION, FILM THICKNESS, AND AZIMUTHAL INSTABILITIES
Atomization and Sprays, Vol.28, 2018, issue 7
Wayne Strasser, Francine Battaglia
PLANAR LIQUID SHEET BREAKUP OF PREFILMING AND NONPREFILMING ATOMIZERS AT ELEVATED PRESSURES
Atomization and Sprays, Vol.19, 2009, issue 12
Umesh Bhayaraju, Christoph Hassa
CHARACTERISTICS OF THE SPRAY PRODUCED BY THE ATOMIZATION OF AN ANNULAR LIQUID SHEET ASSISTED BY AN INNER GAS JET
Atomization and Sprays, Vol.22, 2012, issue 6
Nicolas Leboucher, Francis Roger, Jean-Louis Carreau
EXPERIMENTAL STUDY OF PRIMARY ATOMIZATION IN TRIPLE CO-PLANAR AND NON-PLANAR IMPINGING JETS
Atomization and Sprays, Vol.29, 2019, issue 11
S. Kazemi, Azadeh Kebriaee
EDGE INSTABILITY AND VELOCITY OF LIQUID SHEETS FORMED BY TWO IMPINGING JETS
Atomization and Sprays, Vol.17, 2007, issue 1
Nasser Ashgriz, Ri Li