Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Atomization and Sprays
Fator do impacto: 1.737 FI de cinco anos: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 2.2

ISSN Imprimir: 1044-5110
ISSN On-line: 1936-2684

Volumes:
Volume 30, 2020 Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2013008918
pages 273-280

PREDICTION OF PRESSURE DROP THROUGH BAFFLE INJECTOR

Kyubok Ahn
School of Mechanical Engineering, Chungbuk National University, Chungbuk, Korea
Hwan-Seok Choi
Combustion Chamber Department, Korea Aerospace Research Institute, Daejeon, Korea

RESUMO

The baffle injector in a liquid rocket engine has two special objectives. One is to atomize effectively propellants and the other is to prevent combustion instabilities. A novel analytical method predicting a fuel-side pressure drop through a baffle injector has been suggested. In order to prove the accuracy of the proposed analytical method, three baffle injector models with different hole diameters and cooling channels were manufactured. At the same pressure drop, cold-flow tests using tap water have been carried out for measuring mass flow rates and calculating discharge coefficients. The discharge coefficients measured by the cold-flow tests have been compared with those calculated by the proposed analytical method. It is found that the analytical method can estimate the discharge coefficients within 1% error.


Articles with similar content:

A STUDY ON DISCHARGE COEFFICIENTS OF CLOSED-TYPE SWIRL INJECTORS FOR A LIQUID ROCKET ENGINE
Atomization and Sprays, Vol.27, 2017, issue 7
Kyubok Ahn, Hwan-Seok Choi
FLOW CHARACTERISTICS OF CLOSE-TYPE SWIRL INJECTORS MANUFACTURED BY A 3D PRINTER
Atomization and Sprays, Vol.27, 2017, issue 2
Wonjae Yoon , Kyubok Ahn
EXPERIMENTAL AND COMPUTATIONAL STUDY OF THE INFLUENCE OF PARTIAL NEEDLE LIFT ON NOZZLE FLOWIN DIESEL FUEL INJECTORS
Atomization and Sprays, Vol.22, 2012, issue 8
Jaime Gimeno, Raul Payri, Alejandro H. Plazas, O. Venegas
TWO PARAMETRIC FLOW MEASUREMENT IN GAS-LIQUID TWO-PHASE FLOW
International Heat Transfer Conference 7, Vol.10, 1982, issue
Xu Yinlong , Chen Zhihang, Chen Zuyao, Zhao Zaisan
Precision Setup for Fluid Pump Efficiency Testing
Heat Transfer Research, Vol.28, 1997, issue 7-8
Yu. D. Zozulyak, Yu. L. Levashov, V. T. Novatsky