Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Atomization and Sprays
Fator do impacto: 1.262 FI de cinco anos: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Imprimir: 1044-5110
ISSN On-line: 1936-2684

Volumes:
Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2013007447
pages 211-231

EXPERIMENTAL INVESTIGATIONS ON ADHERED FUEL AND IMPINGING DIESEL SPRAY NORMAL TO A WALL

Mohd Zaid Akop
Division of Mechanical Science and Technology, Faculty of Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, 376-8515, Japan
Yoshio Zama
Division of Mechanical Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, Japan, 376-8515
Tomohiko Furuhata
Division of Mechanical Science and Technology, Faculty of Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, 376-8515, Japan
Masataka Arai
Division of Mechanical Science and Technology, Faculty of Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, 376-8515, Japan; Tokyo Denki University

RESUMO

Since the combustion chamber in a diesel engine is too small to mix injected fuel and surrounding gas perfectly, wall impingement of the spray is considered to be inevitable in the engine. Therefore it is important to understand the basic behavior of impingement spray and the fuel dispersion after impingement. In this paper, the effects of impingement distance, injection pressure, and ambient pressure on the adhering fuel mass of an impinging diesel spray on a normal flat wall were investigated experimentally. Behaviour of diesel fuel spray injected into a high-pressure chamber in cold condition was observed by a high-speed camera. An aluminum circular disk was used as an impingement wall. Adhered fuel mass was measured under conditions of three sizes of circular disk, 20, 30, and 40 mm in diameter. As a result, the adhered mass ratio remarkably increased by an impingement distance increase from 30 to 50 mm. As the injection pressure increased, the adhered mass ratio tended to decrease. Results also showed that less adhering fuel was attained when the height of post-impingement spray increased.