Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.9

ISSN Imprimir: 2152-5102
ISSN On-line: 2152-5110

Volumes:
Volume 47, 2020 Volume 46, 2019 Volume 45, 2018 Volume 44, 2017 Volume 43, 2016 Volume 42, 2015 Volume 41, 2014 Volume 40, 2013 Volume 39, 2012 Volume 38, 2011 Volume 37, 2010 Volume 36, 2009 Volume 35, 2008 Volume 34, 2007 Volume 33, 2006 Volume 32, 2005 Volume 31, 2004 Volume 30, 2003 Volume 29, 2002 Volume 28, 2001 Volume 27, 2000 Volume 26, 1999 Volume 25, 1998 Volume 24, 1997 Volume 23, 1996 Volume 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v35.i1.60
pages 76-93

Flow Characteristics and Local Heat Transfer Rates for a Heated Circular Cylinder in a Crossflow of Air

M. Rafiuddin Ahmed
School of Engineering and Physics, Faculty of Science and Technology, The University of the South Pacific, Suva, Fiji
Fatonga Talama
School of Engineering and Physics Faculty of Science and Technology The University of the South Pacific, Laucala Campus, Suva, Fiji

RESUMO

The flow characteristics and the local heat transfer by forced convection for a heated circular cylinder are investigated experimentally at four Reynolds numbers from 16285 to 65140 in a low speed wind tunnel. Three cylinders, made of Aluminum, Brass and Stainless Steel were tested. The pressure distribution on the surface was obtained along with the temperature distribution at a number of locations. The wake region was explored to gain an understanding of the flow pattern on the back of the cylinder. An innovative technique of accounting for all the heat input was employed in this investigation. The heat transfer by forced convection is found to be higher near the stagnation point and near the base of the cylinder due to zero thickness of the boundary layer and intense mixing in the separated flow region respectively. The values of Nusselt number obtained from the heat loss recorded at different circumferential locations, and averaged over the values for the three cylinders, are compared with the values calculated from the empirical correlations proposed by previous investigators.


Articles with similar content:

HEAT TRANSFER ENHANCEMENT DOWNSTREAM OF VORTEX GENERATORS ON A FLAT PLATE
International Heat Transfer Conference 8, Vol.6, 1986, issue
A. Y. Turk , G. H. Junkhan
TRANSIENT CROSS-FLOW MIXED CONVECTION ADJACENT TO AN ISOTHERMAL VERTICAL PLATE IN AIR
International Heat Transfer Conference 8, Vol.3, 1986, issue
Van P. Carey, M.M. Rahman
ACTIVE CONTROL OF VORTEX SHEDDING FROM A CYLINDER
TSFP DIGITAL LIBRARY ONLINE, Vol.2, 2001, issue
Hani H. Nigim, Hide S. Koyama , Oeh Tathoyh
Heat Transfer in a Perpendicular Arrangement of Cylinders in Steady and Pulsating Crossflow
International Heat Transfer Conference 8, Vol.3, 1986, issue
Thomas E. Diller, T. M. VandenBerghe
EXPERIMENTAL STUDY OF THE EFFECT OF FLAT-PLATE WAKE ON MASS TRANSFER ABOUT A CYLINDER IN CROSSFLOW
International Heat Transfer Conference 10, Vol.6, 1994, issue
Joon Sik Lee, Hyunsik Kim, D. J. Maeng