RT Journal Article ID 4892b76c4e2861a7 A1 Konovalenko, Alexandr A. A1 Zhouck, I. N. A1 Gridin, A. A. A1 Bovkoon, V. P. A1 Boobnov, I. N. T1 A SUPER-WIDEBAND BASIC ELEMENT FOR LOW-FREQUENCY ANTENNAS OF RADIO TELESCOPES: PART 1. PRINCIPLES OF REALIZATION JF Radio Physics and Radio Astronomy JO RPRA YR 2011 FD 2011-04-29 VO 2 IS 2 SP 105 OP 113 K1 radio telescope antenna K1 coaxial line K1 horizontally oriented dipole K1 super-wideband dipole AB Discussed in the paper are requirements to the super-wideband basic element of the radio telescope antenna operating below 200 MHz, as well as the principles underlying realization of such passive, short, symmetric, horizontally oriented dipole and possibilities for its matching with the high frequency (h.f.) feed of the telescope’s antenna array. It is shown that, despite the sharp variations of the dipole’s input impedance, it proves possible to obtain, taken the high effective temperature of the celestial sphere, a degree of matching characterized by a SWR lower than 3 over the frequency band 12.5 to 60 MHz. Within this band the antenna sensitivity is not reduced by more than 0.5 dB relative to the value for a fully matched lossless half-wave antenna. The effect is achieved by means of connecting an additional attenuator in series with the input impedance of the antenna’s basic element. As a result, the ohmic component of the input impedance is leveled through the band of 12.5 to 60 MHz. Coaxial line sections with a common central conductor are used as arms of the antenna basic element, which provides for a 0.8 to 1.0 coupling between the line sections (i.e. aperiodic circuits), and a substantially depressed reactive component of the element’s input impedance. PB Begell House LK https://www.dl.begellhouse.com/journals/6fd1549c0e2c05da,35f7715f4b3f1eab,4892b76c4e2861a7.html