Inscrição na biblioteca: Guest
Annual Review of Heat Transfer
Vish Prasad (open in a new tab) Department of Mechanical Engineering, University of North Texas, Denton, Texas 76207, USA
Yogesh Jaluria (open in a new tab) Department of Mechanical and Aerospace Engineering, Rutgers-New Brunswick, The State University of New Jersey, Piscataway, NJ 08854, USA
Zhuomin M. Zhang (open in a new tab) George W. Woodruff School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, GA 30332, USA

ISSN Print: 1049-0787

ISSN Online: 2375-0294

SJR: 0.363 SNIP: 0.21 CiteScore™:: 1.8

Indexed in

Clarivate CBCI (Books) Scopus Google Scholar CNKI Portico Copyright Clearance Center iThenticate Scientific Literature

MODELS OF THE THERMODYNAMIC AND KINETIC BEHAVIOR OF FUEL CELLS AND THEIR USE IN THE RATIONAL DESIGN OF FUEL CELL ELECTRODES

pages 529-576
DOI: 10.1615/AnnualRevHeatTransfer.v14.290
Get accessGet access

RESUMO

The performance of low temperature fuel cells, such as proton exchange membrane fuel cells (PEMFC) and phosphoric acid fuel cells (PAFC), is largely controlled by the microstructures that make up the catalyst layer of the air/oxygen electrode. In state of the art fuel cells, the microstructures are formed by conventional fabrication techniques like rolling, printing, or spraying the catalyst ink onto a gas backing layer or an electrolyte membrane. Conventional fabrication techniques provide little control over the geometry and distribution of these structures within the catalyst layer. Consequently, catalyst layers are not ideal structures that operate only under activation control. Instead, fuel cell electrodes suffer from low catalyst utilization and contain microstructures that are not optimal for transport of reactants and products. Microfabrication is a proposed method for constructing electrodes that address the limitations posed by existing fabrication techniques. The advantage of microfabrication comes from its ability to provide greater control over the geometry and distribution of the microstructures that make up the catalyst layer. This added control, allows for a more efficient use of the catalyst at the desired operating conditions of the fuel cell. The first half of this chapter provides a brief review of fuel cell technology as well as an introduction to the kinetic and transport equations that are often used to model the physics within the active regions of the cell. In the second half of this chapter one embodiment of the microfabricated electrode concept is described. A simple 1-D model is then presented to demonstrate the possible improvement in fuel cell performance that a microfabricated air electrode can provide.

Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa Políticas de preços e assinaturas Begell House Contato Language English 中文 Русский Português German French Spain