Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
Journal of Porous Media
Импакт фактор: 1.49 5-летний Импакт фактор: 1.159 SJR: 0.43 SNIP: 0.671 CiteScore™: 1.58

ISSN Печать: 1091-028X
ISSN Онлайн: 1934-0508

Выпуски:
Том 23, 2020 Том 22, 2019 Том 21, 2018 Том 20, 2017 Том 19, 2016 Том 18, 2015 Том 17, 2014 Том 16, 2013 Том 15, 2012 Том 14, 2011 Том 13, 2010 Том 12, 2009 Том 11, 2008 Том 10, 2007 Том 9, 2006 Том 8, 2005 Том 7, 2004 Том 6, 2003 Том 5, 2002 Том 4, 2001 Том 3, 2000 Том 2, 1999 Том 1, 1998

Journal of Porous Media

DOI: 10.1615/JPorMedia.v10.i2.30
pages 137-150

Experimental Evaluation of Evaporation Enhancement with Porous Media in Liquid-Fueled Burners

Chendhil Periasamy
Combustion and Flame Dynamics Laboratory, School of Aerospace and Mechanical Engineering, 865 Asp Ave, Room 212, The University of Oklahoma, Norman, OK 73019; and Now at Air Liquide R&D, Newark, DE 19702, USA
Sathish K. Sankara-Chinthamony
Combustion and Flame Dynamics Laboratory, School of Aerospace and Mechanical Engineering, 865 Asp Ave, Room 212, The University of Oklahoma, Norman, OK 73019, USA
Subramanyam R. Gollahalli
Combustion and Flame Dynamics Laboratory, School of Aerospace and Mechanical Engineering, 865 Asp Ave, Room 212, The University of Oklahoma, Norman, OK 73019, USA

Краткое описание

Potential benefits of using a porous medium to enhance evaporation in liquid-fueled burners have been experimentally evaluated. An open-cell, silicon carbide-coated, carbon-carbon ceramic foam was used as a porous medium. Aviation-type kerosene was sprayed into a coflowing, preheated air environment using an air-blast atomizer, and the spray subsequently entered the porous medium. The minimum combustion heat feedback rate required for complete vaporization and the vapor concentration downstream of the porous medium were measured. Surface temperature measurements showed that the temperature of the porous medium was uniform within 10 K. The minimum heat feedback rate required for complete vaporization increased as the distance between the porous medium and the injector was decreased. Under the present conditions, with porous media and combustion heat feedback, complete vaporization was achieved at a coflow air temperature of 400 K. Without porous media, however, a minimum coflow air temperature of 500 K was required to achieve the same quality of evaporation. Measurements revealed that a combustion heat feedback rate of 1% produced average vapor concentrations of 63% and 43% more than that with no heat feedback at equivalence ratios of 0.3 and 0.6, respectively.