Доступ предоставлен для: Guest

EXPERIMENTAL ANALYSIS AND TRANSIENT SIMULATION OF HEAT TRANSFER INSIDE THE FINNED TUBE ADSORBENT BED OF A THERMAL WAVE CYCLE

Том 22, Выпуск 4, 2019, pp. 467-479
DOI: 10.1615/JPorMedia.2019028672
Get accessGet access

Краткое описание

Heat transfer enhancement inside the adsorbent bed of a thermal wave adsorption cooling cycle is investigated both experimentally and theoretically. Various adsorbent materials are tested using a finned tube adsorbent bed for the thermal wave cycle. The mathematical model is well defined, including a 2-D coupled heat and mass transfer analysis. This study presents the effects of heat transfer fluid velocity, regeneration temperature, condenser pressure, and particle diameter on the heat transfer enhancement inside the bed. For verification of the theoretical model, temperature measurements were taken in both radial and axial directions. As a result of the experimental study, a good agreement is achieved between the predictions and experiments.

ЛИТЕРАТУРА
  1. Amar, N.B., Sun, L.M., and Meunier, F., Numerical Analysis of Adsorptive Temperature Wave Regenerative Heat Pump, Appl. Therm. Eng., vol. 16, no. 5, pp. 405–418, 1996.

  2. Chan, K.C., Chao, C.Y.H., and Wu, C.L., Measurement of Properties and Performance Prediction of the New MWCNT-Embedded Zeolite 13X/CaCl<sub>2</sub> Composite Adsorbents, Int. J. Heat Mass Transf., vol. 89, pp. 308–319, 2015.

  3. Chua, H.T., Ng, K.C., Malek, A., Kashiwagi, T., Akisawa, A., and Saha, B.B., Modeling the Performance of Two-Bed, Silica Gel-Water Adsorption Chillers, Int. J. Refrig., vol. 22, no. 3, pp. 194–204, 1999.

  4. Chua, H.T., Ng, K.C.,Wang,W., Yap, C., and Wang, X.L., Transient Modeling of a Two-Bed Silica Gel–Water Adsorption Chiller, Int. J. Heat Mass Transf., vol. 47, no. 4, pp. 659–669, 2004.

  5. Critoph, R.E., Forced Convection Adsorption Cycles, Appl. Therm. Eng., vol. 18, pp. 799–807, 1998.

  6. Critoph, R.E. and Turner, L.H., Performance of Ammonia-Activated Carbon and Ammonia Zeolite Heat Pump Adsorption Cycles, Proc. Conf. Pompes a Chaleur Chimiques De Hautes Performances, Perpignan, France, pp. 202–211, 1989.

  7. Caglar, A., The Effect of Fin Design Parameters on the Heat Transfer Enhancement in the Adsorbent Bed of a Thermal Wave Cycle, Appl. Therm. Eng., vol. 104, pp. 386–393, 2016.

  8. Caglar, A. and Yamali, C., Analysis of Heat and Mass Transfer in the Adsorbent Bed of a Thermal Wave Adsorption Cooling Cycle, Comput. Therm. Sci., vol. 5, no. 2, pp. 97–106, 2013.

  9. Caglar, A., Yamali, C., and Baker, D.K., Two Dimensional Transient Coupled Analysis of a Finned Tube Adsorbent Bed for a Thermal Wave Cycle, Int. J. Therm. Sci., vol. 73, pp. 58–68, 2013.

  10. Demir, H., Mobedi, M., and Ulku, S., A Review on Adsorption Heat Pump: Problems and Solutions, Renewable Sustainable Energy Rev., vol. 12, pp. 2381–2403, 2008.

  11. Ellis, M.W., An Evaluation of the Effect of Adsorbent Properties on the Performance of a Solid Sorption Heat Pump, PhD, Georgia Institute of Technology, 1996.

  12. Lai, H.-M., An Enhanced Adsorption Cycle Operated by Periodic Reversal Forced Convection, Appl. Therm. Eng., vol. 20, pp. 595–617, 2000.

  13. Lambert, M.A., Design of Solar Powered Adsorption Heat Pump with Ice Storage, Appl. Therm. Eng., vol. 27, pp. 1612–1628, 2007.

  14. Li, A., Thu, K., Ismail, A.B., Shahzad, M.W., and Ng, K.C., Performance of Adsorbent-Embedded Heat Exchangers using Binder- Coating Method, Int. J. Heat Mass Transf., vol. 92, pp. 149–157, 2016.

  15. Liu, Y. and Leong, K.C., Numerical Study of a Novel Cascading Adsorption Cycle, Int. J. Refrig., vol. 29, pp. 250–259, 2006.

  16. Maggio, G., Freni, A., and Restuccia, G., A Dynamic Model of Heat and Mass Transfer in a Double-Bed Adsorption Machine with Internal Heat Recovery, Int. J. Refrig., vol. 29, no. 4, pp. 589–600, 2006.

  17. Meunier, F., Solid Sorption Heat Powered Cycles for Cooling and Heat Pumping Applications, Appl. Therm. Eng., vol. 18, pp. 715–729, 1998.

  18. Pons, M. and Feng, Y., Characteristic Parameters of Adsorptive Refrigeration Cycles with Thermal Regeneration, Appl. Therm. Eng., vol. 17, no. 3, pp. 289–298, 1997.

  19. Qu, T.F., Wang, R.Z., and Wang, W., Study on Heat and Mass Recovery in Adsorption Refrigeration Cycles, Appl. Therm. Eng., vol. 21, pp. 439–452, 2001.

  20. Shelton, S.V., Wepfer, W.J., and Miles, D.J., Square Wave Analysis of the Solid-Vapor Adsorption Heat Pump, Heat Recovery Syst. CHP, vol. 9, no. 3, pp. 233–247, 1989.

  21. Shelton, S.V., Wepfer, W.J., and Miles, D.J., Ramp Wave Analysis of the Solid/Vapor Heat Pump, J. Energy Res. Technol., vol. 112, pp. 69–78, 1990.

  22. Solmus,I., Rees, D.A.S., Yamali, C., Baker, D., and Kaftanoglu, B., Numerical Investigation of Coupled Heat and Mass Transfer inside the Adsorbent Bed of an Adsorption Cooling Unit, Int. J. Refrig., vol. 35, pp. 652–662, 2012.

  23. Solmus,I., Yamali, C., Kaftanoglu, B., Baker, D., and Caglar, A., Adsorption Properties of a Natural Zeolite-Water Pair for Use in Adsorption Cooling Cycles, Appl. Energy, vol. 87, pp. 2062–2067, 2010.

  24. Sun, B. and Chakraborty, A., Thermodynamic Frameworks of Adsorption Kinetics Modeling: Dynamic Water Uptakes on Silica Gel for Adsorption Cooling Applications, Energy, vol. 84, pp. 296–302, 2015.

  25. Sun, L.M., Feng, Y., and Pons, M., Numerical Investigation of Adsorptive Heat Pump Systems with Thermal Wave Heat Regeneration under Uniform-Pressure Conditions, Int. J. Heat Mass Transf., vol. 40, no. 2, pp. 281–293, 1997.

  26. Sward, B.K., LeVan, M.D., and Meunier, F., Adsorption Heat Pump Modeling: The ThermalWave Process with Local Equilibrium, Appl. Therm. Eng., vol. 20, pp. 759–780, 2000.

  27. Taylan, O., Baker, D.K., and Kaftanoglu, B., COP Trends for Ideal ThermalWave Adsorption Cooling Cycles with Enhancements, Int. J. Refrig., vol. 35, pp. 562–570, 2012.

  28. Tierney, M.J., Feasibility of Driving Convective Thermal Wave Chillers with Low-Grade Heat, Renewable Energy, vol. 33, pp. 2097–2108, 2008.

  29. Wang, L.W., Wang, R.Z., and Oliveira, R.G. , A Review on Adsorption Working Pairs for Refrigeration, Renewable Sustainable Energy Rev., vol. 13, pp. 518–534, 2009.

  30. Zhang, L.Z., A Three-Dimensional Non-Equilibrium Model for an Intermittent Adsorption Cooling System, Sol. Energy, vol. 69, no. 1, pp. 27–35, 2000.

ЦИТИРОВАНО В
  1. Safikhani Hamed, SELECTING THE OPTIMAL ARRANGEMENTS OF POROUS BLOCKS WITH DIFFERENT/SIMILAR PROPERTIES IN A TWO-DIMENSIONAL CHANNEL ACCORDING TO THE THERMO-HYDRODYNAMIC PERFORMANCE OF THE SYSTEM: A NUMERICAL STUDY , Journal of Porous Media, 25, 10, 2022. Crossref

Статьи, принятые к публикации

ON THERMAL CONVECTION IN ROTATING CASSON NANOFLUID PERMEATED WITH SUSPENDED PARTICLES IN A DARCY-BRINKMAN POROUS MEDIUM Pushap Sharma, Deepak Bains, G. C. Rana Effect of Microstructures on Mass Transfer inside a Hierarchically-structured Porous Catalyst Masood Moghaddam, Abbas Abbassi, Jafar Ghazanfarian Insight into the impact of melting heat transfer and MHD on stagnation point flow of tangent hyperbolic fluid over a porous rotating disk Priya Bartwal, Himanshu Upreti, Alok Kumar Pandey Numerical Simulation of 3D Darcy-Forchheimer Hybrid Nanofluid Flow with Heat Source/Sink and Partial Slip Effect across a Spinning Disc Bilal Ali, Sidra Jubair, Md Irfanul Haque Siddiqui Fractal model of solid-liquid two-phase thermal transport characteristics in the rough fracture network shanshan yang, Qiong Sheng, Mingqing Zou, Mengying Wang, Ruike Cui, Shuaiyin Chen, Qian Zheng Application of Artificial Neural Network for Modeling of Motile Microorganism-Enhanced MHD Tangent Hyperbolic Nanofluid across a vertical Slender Stretching Surface Bilal Ali, Shengjun Liu, Hongjuan Liu Estimating the Spreading Rates of Hazardous Materials on Unmodified Cellulose Filter Paper: Implications on Risk Assessment of Transporting Hazardous Materials Heshani Manaweera Wickramage, Pan Lu, Peter Oduor, Jianbang Du ELASTIC INTERACTIONS BETWEEN EQUILIBRIUM PORES/HOLES IN POROUS MEDIA UNDER REMOTE STRESS Kostas Davanas Gravity modulation and its impact on weakly nonlinear bio-thermal convection in a porous layer under rotation: a Ginzburg-Landau model approach Michael Kopp, Vladimir Yanovsky Pore structure and permeability behavior of porous media under in-situ stress and pore pressure: Discrete element method simulation on digital core Jun Yao, Chunqi Wang, Xiaoyu Wang, Zhaoqin Huang, Fugui Liu, Quan Xu, Yongfei Yang Influence of Lorentz forces on forced convection of Nanofluid in a porous lid driven enclosure Yi Man, Mostafa Barzegar Gerdroodbary SUTTERBY NANOFLUID FLOW WITH MICROORGANISMS AROUND A CURVED EXPANDING SURFACE THROUGH A POROUS MEDIUM: THERMAL DIFFUSION AND DIFFUSION THERMO IMPACTS galal Moatimid, Mona Mohamed, Khaled Elagamy CHARACTERISTICS OF FLOW REGIMES IN SPIRAL PACKED BEDS WITH SPHERES Mustafa Yasin Gökaslan, Mustafa Özdemir, Lütfullah Kuddusi Numerical study of the influence of magnetic field and throughflow on the onset of thermo-bio-convection in a Forchheimer‑extended Darcy-Brinkman porous nanofluid layer containing gyrotactic microorganisms Arpan Garg, Y.D. Sharma, Subit K. Jain, Sanjalee Maheshwari A nanofluid couple stress flow due to porous stretching and shrinking sheet with heat transfer A. B. Vishalakshi, U.S. Mahabaleshwar, V. Anitha, Dia Zeidan ROTATING WAVY CYLINDER ON BIOCONVECTION FLOW OF NANOENCAPSULATED PHASE CHANGE MATERIALS IN A FINNED CIRCULAR CYLINDER Noura Alsedais, Sang-Wook Lee, Abdelraheem Aly Porosity Impacts on MHD Casson Fluid past a Shrinking Cylinder with Suction Annuri Shobha, Murugan Mageswari, Aisha M. Alqahtani, Asokan Arulmozhi, Manyala Gangadhar Rao, Sudar Mozhi K, Ilyas Khan CREEPING FLOW OF COUPLE STRESS FLUID OVER A SPHERICAL FIELD ON A SATURATED BIPOROUS MEDIUM Shyamala Sakthivel , Pankaj Shukla, Selvi Ramasamy
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции Цены и условия подписки Begell House Контакты Language English 中文 Русский Português German French Spain