Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
Atomization and Sprays
Импакт фактор: 1.262 5-летний Импакт фактор: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Печать: 1044-5110
ISSN Онлайн: 1936-2684

Выпуски:
Том 29, 2019 Том 28, 2018 Том 27, 2017 Том 26, 2016 Том 25, 2015 Том 24, 2014 Том 23, 2013 Том 22, 2012 Том 21, 2011 Том 20, 2010 Том 19, 2009 Том 18, 2008 Том 17, 2007 Том 16, 2006 Том 15, 2005 Том 14, 2004 Том 13, 2003 Том 12, 2002 Том 11, 2001 Том 10, 2000 Том 9, 1999 Том 8, 1998 Том 7, 1997 Том 6, 1996 Том 5, 1995 Том 4, 1994 Том 3, 1993 Том 2, 1992 Том 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.v14.i4.40
22 pages

CHARACTERISTICS OF SPRAYS THROUGH A WALL IMPINGEMENT INJECTOR

Takao Inamura
Graduate School of Science and Technology, Hirosaki University, Japan
Terutoshi Tomoda
Engine Engineering Dev. 2, Toyota Motor Corporation, Susono-shi, Shizuoka-ken, Japan 410-1193

Краткое описание

The behavior of a liquid film generated by the impingement of a liquid jet onto a solid wall was investigated for the purpose of its application to the design of an injector equipped with a direct-injection spark-ignition (DISI) engine. The liquid nozzle newly developed by the authors generates little turbulence in a liquid flow. The characteristics of a liquid film issuing from the edge of a solid wall (such as film spread angle and spray tip penetration) were measured by varying the injection conditions. The fuel injector was developed based on these basic experiments. The size of spray droplets injected through this injector was measured using a phase Doppler particle analyzer (PDPA), and the results were compared with those from the conventional slit-type injector. At the center of the spray, the droplet size distribution peaks at the small droplet diameter. At the periphery, this distribution peaks at a larger droplet diameter than at the center, but the distribution becomes narrower. The mean droplet size decreases gradually toward the periphery and then increases in size. The Sauter mean diameter of the spray injected through the newly developed injector ranges from 17 to 27 μm. The wall impingement-type injector has the potential to control the spray configuration by the impingement conditions and the shape of the wall surface.