Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
Atomization and Sprays
Импакт фактор: 1.737 5-летний Импакт фактор: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 2.2

ISSN Печать: 1044-5110
ISSN Онлайн: 1936-2684

Выпуски:
Том 30, 2020 Том 29, 2019 Том 28, 2018 Том 27, 2017 Том 26, 2016 Том 25, 2015 Том 24, 2014 Том 23, 2013 Том 22, 2012 Том 21, 2011 Том 20, 2010 Том 19, 2009 Том 18, 2008 Том 17, 2007 Том 16, 2006 Том 15, 2005 Том 14, 2004 Том 13, 2003 Том 12, 2002 Том 11, 2001 Том 10, 2000 Том 9, 1999 Том 8, 1998 Том 7, 1997 Том 6, 1996 Том 5, 1995 Том 4, 1994 Том 3, 1993 Том 2, 1992 Том 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2013006811
pages 763-797

ONSET OF ATOMIZATION ON HORIZONTAL, SHEAR-DRIVEN LIQUID FILMS AT THE VICINITY OF A SHARP CORNER

Evangelos Bacharoudis
Universitu Lille Nord de France, 59000 Lille, France, UVHC, TEMPO 59313 Valenciennes, France; von Karman Institute for Fluid Dynamics, Rhode-St-Genese, Belgium
Herve Bratec
Robert Bosch Produktie N.V., Tienen, Belgium
Laurent Keirsbulck
Universitu Lille Nord de France, 59000 Lille, France, UVHC, TEMPO 59313 Valenciennes, France
Jean-Marie Buchlin
von Karman Institute for Fluid Dynamics, Rhode-St-Genese, Belgium
Larbi Labraga
Universitu Lille Nord de France, 59000 Lille, France, UVHC, TEMPO 59313 Valenciennes, France

Краткое описание

In many engineering applications, the liquid films have to deal with sudden changes of the wall geometries in which they flow over. The present work concerns the study of the onset of the film atomization in corner geometries. Specifically, films with thickness in the range of 1 mm < hf < 2.5 mm and dimensionless scale parameters in the range of 2 < ε · Ref < 24, able to expand in a spanwise direction without side restrictions, are developed on a horizontal plate. The films approach a sharp corner of 90° at the end of the plate under the shearing action of an external airflow. The air velocity and the liquid flow rate in which the film atomization at the corner edge initiates are detected experimentally. The behavior of the mean film and its waves at the corner are studied under those conditions. Both the viscosity and the surface tension are varied to investigate the effect of the liquid properties on the onset of the film atomization. The experimental data obtained here are compared extensively with the atomization models found in the open literature. The comparison shows that the existing models are not able to predict the onset of atomization for the films of the current work. That happens mainly because the interfacial waves have been totally neglected from the models. Further theoretical development is required to successfully predict the initiation of the droplet generation in corner geometries.


Articles with similar content:

AN EXPERIMENTAL INVESTIGATION OF THE FLASH ATOMIZATION MECHANISM
Atomization and Sprays, Vol.4, 1994, issue 2
Byung Suh Park, Sang Yong Lee
EFFECTS OF FLUID PROPERTIES ON THE CHARACTERISTICS OF IMPINGING-JET SPRAYS
Atomization and Sprays, Vol.15, 2005, issue 4
Wennon Huang, Tzu-Hong Huang, Tsung-Leo Jiang, Wei-Hsiang Lai
EVAPORATING SPRAY SIMULATION IN A DIRECT INJECTION MODEL ENGINE
International Heat Transfer Conference 10, Vol.19, 1994, issue
Hong Sun Ryou, H.C. Yang, Young Ki Choi
THE EFFECTS OF GAS LAYER AND LIQUID PHYSICAL PROPERTIES ON THE BREAKUP OF COAXIAL LIQUID JET SPRAY
Atomization and Sprays, Vol.26, 2016, issue 6
Marx Tang, Tony Yuan
DIRECT NUMERICAL AND LARGE-EDDY SIMULATION OF PRIMARY ATOMIZATION IN COMPLEX GEOMETRIES
Atomization and Sprays, Vol.23, 2013, issue 11
Peter Brady, Mark Owkes, Olivier Desjardins, Jeremy McCaslin