Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
Atomization and Sprays
Импакт фактор: 1.737 5-летний Импакт фактор: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 2.2

ISSN Печать: 1044-5110
ISSN Онлайн: 1936-2684

Выпуски:
Том 30, 2020 Том 29, 2019 Том 28, 2018 Том 27, 2017 Том 26, 2016 Том 25, 2015 Том 24, 2014 Том 23, 2013 Том 22, 2012 Том 21, 2011 Том 20, 2010 Том 19, 2009 Том 18, 2008 Том 17, 2007 Том 16, 2006 Том 15, 2005 Том 14, 2004 Том 13, 2003 Том 12, 2002 Том 11, 2001 Том 10, 2000 Том 9, 1999 Том 8, 1998 Том 7, 1997 Том 6, 1996 Том 5, 1995 Том 4, 1994 Том 3, 1993 Том 2, 1992 Том 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2017019293
pages 835-846

AN EXTENSIVE STUDY ON THE DISCHARGE COEFFICIENTS OF OPEN-TYPE SWIRL INJECTORS

Kyubok Ahn
School of Mechanical Engineering, Chungbuk National University, Chungbuk, Korea
Hwan-Seok Choi
Combustion Chamber Department, Korea Aerospace Research Institute, Daejeon, Korea

Краткое описание

Extensive studies on the discharge coefficients of open-type swirl injectors, which have a swirl chamber diameter equal to their nozzle diameter, have been conducted. Nineteen open-type swirl injectors with a broad range of swirl injector geometric constants from 2.86 to 18.13 were designed and manufactured. When varying the injection pressure drop from approximately 8 bar to 12 bar, static pressure and flow rate data were collected and analyzed to calculate the discharge coefficient. The measured discharge coefficients were confirmed to be precisely expressed as a function of the swirl injector geometric constant. Previous empirical equations, respectively induced from closed-type swirl injectors and open-type swirl injectors, were compared with the present experimental results to examine their accuracy. Though previous equations from open-type swirl injectors were better than those from closed-type swirl injectors, most of the equations could not satisfactorily predict the discharge coefficients from the present study. Two novel equations for the discharge coefficient of open-type swirl injectors are suggested: one was empirically obtained through a linear regression analysis of the present test data and the other was derived by modifying the design method of the closed-type swirl injector. It was found that both the modified design method and the present empirical equation matched well with the experimental data. Another equation, which can be used both for closed-type and open-type swirl injectors, is also proposed from a non-linear regression analysis using previous and present experimental data.


Articles with similar content:

A STUDY ON DISCHARGE COEFFICIENTS OF CLOSED-TYPE SWIRL INJECTORS FOR A LIQUID ROCKET ENGINE
Atomization and Sprays, Vol.27, 2017, issue 7
Kyubok Ahn, Hwan-Seok Choi
SPRAY CHARACTERISTICS OF AN OPEN-END SWIRL INJECTOR
Atomization and Sprays, Vol.22, 2012, issue 5
Wei Zhang, Qing-Fei Fu, Kun-Da Cui, Li-Jun Yang
OPTIMAL AND NONOPTIMAL FLOWS IN A SWIRL ATOMIZER
Atomization and Sprays, Vol.19, 2009, issue 12
S. N. Patel, L. Craig, B. Kanya, Nathaniel Barlow, Sung P. Lin
CHARACTERIZATION OF PROTOTYPE HIGH-PRESSURE SWIRL INJECTOR NOZZLES, PART II: CFD EVALUATION OF INTERNAL FLOW
Atomization and Sprays, Vol.10, 2000, issue 2
Sangmin Choi, Changsoo Jang, Choongsik Bae
FURTHER DEVELOPMENTS OF A NOVEL SELF-DRIVEN SPRAY NOZZLE
Atomization and Sprays, Vol.16, 2006, issue 7
Weiping Liu, George H. Smith, Edward H. Owens, Mark T. Leonard