Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
Atomization and Sprays
Импакт фактор: 1.262 5-летний Импакт фактор: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Печать: 1044-5110
ISSN Онлайн: 1936-2684

Выпуски:
Том 29, 2019 Том 28, 2018 Том 27, 2017 Том 26, 2016 Том 25, 2015 Том 24, 2014 Том 23, 2013 Том 22, 2012 Том 21, 2011 Том 20, 2010 Том 19, 2009 Том 18, 2008 Том 17, 2007 Том 16, 2006 Том 15, 2005 Том 14, 2004 Том 13, 2003 Том 12, 2002 Том 11, 2001 Том 10, 2000 Том 9, 1999 Том 8, 1998 Том 7, 1997 Том 6, 1996 Том 5, 1995 Том 4, 1994 Том 3, 1993 Том 2, 1992 Том 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2013007447
pages 211-231

EXPERIMENTAL INVESTIGATIONS ON ADHERED FUEL AND IMPINGING DIESEL SPRAY NORMAL TO A WALL

Mohd Zaid Akop
Division of Mechanical Science and Technology, Faculty of Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, 376-8515, Japan
Yoshio Zama
Division of Mechanical Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, Japan, 376-8515
Tomohiko Furuhata
Division of Mechanical Science and Technology, Faculty of Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, 376-8515, Japan
Masataka Arai
Division of Mechanical Science and Technology, Faculty of Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma, 376-8515, Japan; Tokyo Denki University

Краткое описание

Since the combustion chamber in a diesel engine is too small to mix injected fuel and surrounding gas perfectly, wall impingement of the spray is considered to be inevitable in the engine. Therefore it is important to understand the basic behavior of impingement spray and the fuel dispersion after impingement. In this paper, the effects of impingement distance, injection pressure, and ambient pressure on the adhering fuel mass of an impinging diesel spray on a normal flat wall were investigated experimentally. Behaviour of diesel fuel spray injected into a high-pressure chamber in cold condition was observed by a high-speed camera. An aluminum circular disk was used as an impingement wall. Adhered fuel mass was measured under conditions of three sizes of circular disk, 20, 30, and 40 mm in diameter. As a result, the adhered mass ratio remarkably increased by an impingement distance increase from 30 to 50 mm. As the injection pressure increased, the adhered mass ratio tended to decrease. Results also showed that less adhering fuel was attained when the height of post-impingement spray increased.