Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
Interfacial Phenomena and Heat Transfer
ESCI SJR: 0.146

ISSN Печать: 2169-2785
ISSN Онлайн: 2167-857X

Open Access

Interfacial Phenomena and Heat Transfer

DOI: 10.1615/InterfacPhenomHeatTransfer.2013010209
pages 207-214

HOW ROBUST IS THE RING STAIN FOR EVAPORATING SUSPENSION DROPLETS?

Y. Msambwa
School of Science and Technology, Nottingham Trent University, Clifton Lane, Nottingham, NG11 8NS, United Kingdom
David J. Fairhurst
Nottingham Trent University, School of Science and Technology, Nottingham, United Kingdom
F. Ouali
School of Science and Technology, Nottingham Trent University, Clifton Lane, Nottingham, NG11 8NS, United Kingdom

Краткое описание

The ring stain is commonly seen when droplets containing particles, such as coffee, are left to dry on a surface: a pinned contact line leads to outward radial flow, which is enhanced by the diverging evaporative flux at the contact line. As shown by Deegan et al. (1997) particles are swept outwards in this flow and create a ring which grows according to a simple power law with time. The final dried width and height of the ring should also be given by power laws of concentration, with both exponent equal to 0.5 provided all particles are in the ring, and the packing factor and ring profile are constant. We use suspensions of polystyrene particles in water with sizes ranging from 200 to 500 nm and initial concentrations c0 from 0.009% to 1% deposited on glass substrates to investigate these scaling predictions. We vary the drying rate from 0.5 to 5 nl/s using humidity and reduced pressure, use a range of substrates to vary the initial contact angle between 5° and 35°, and invert the droplets to change the direction of gravity. We find that for all but the very lowest pressures, the ring height follows the predicted power law, with exponent equal to 0.50 ± 0.04 and the ring width having an exponent of 0.33 ± 0.05. The discrepancy between the measured and predicted width exponent is accounted for by an observed variation of droplet radius with concentration, and the presence of particles in the center of the droplet. In addition, for low pressures (fast evaporation) the scaling laws no longer hold: the ring is much narrower and there is significant deposition in the center of the droplet, possibly due to reduced particle-enhanced pinning.

Ключевые слова: droplet, evaporation, particle, deposit, ring-stain