每年出版 12 期
ISSN 打印: 1044-5110
ISSN 在线: 1936-2684
Indexed in
ATOMIZATION CHARACTERISTICS OF JET-TO-JET AND SPRAY-TO-SPRAY IMPINGEMENT SYSTEMS
摘要
Atomization characteristics in a mutual-impingement spray system was investigated experimentally. The sprays injected from two conventional electronic fuel injection (EFI) nozzles or spraying nozzles were impinged at various impingement locations and impingement angles. When the impingement took place in the vicinity of the nozzle, a jet-to-jet impingement was observed, while a spray-to-spray impingement was observed in the case of mutual impingement of fully developed sprays which formed far away from the nozzle. The results showed that the spray tip penetration in the case of jet-to-jet impingement became short compared with that of the free spray (nonimpingement). On the other hand, in the case of spray-to-spray impingement, the spray tip penetration was almost the same as that of the free spray. Also, the reduction of Sauter mean diameter (SMD) was caused by the film disintegration after the impingement in both cases, jet-to-jet and spray-to-spray impingement. The SMD after the jet-to-jet impingement was approximately one-half of that of the free spray. In the case of the spray-to-spray impingement, it was observed that the liquid film was formed by the droplet collisions in the spray and the film disintegrated into many fine droplets. The SMD reduction after the spray-to-spray impingement was about 70−80% of that of the free spray.
-
Ko Gwon Hyun, Ryou Hong Sun, Hur Nahm Keon, Ko Seung Woo, Youn Myoung O., Numerical study on bouncing and separation collision between two droplets considering the collision-induced breakup, Journal of Mechanical Science and Technology, 21, 4, 2007. Crossref
-
Nishida Keiya, Tian Jiangping, Sumoto Yasuki, Long Wuqiang, Sato Kiyotaka, Yamakawa Masahisa, An experimental and numerical study on sprays injected from two-hole nozzles for DISI engines, Fuel, 88, 9, 2009. Crossref
-
Ko Gwon Hyun, Ryou Hong Sun, Modeling of droplet collision-induced breakup process, International Journal of Multiphase Flow, 31, 6, 2005. Crossref
-
Ko Gwon Hyun, Ryou Hong Sun, Droplet collision processes in an inter-spray impingement system, Journal of Aerosol Science, 36, 11, 2005. Crossref
-
Ghasemi A., Barron R.M., Balachandar R., Spray-induced air motion in single and twin ultra-high injection diesel sprays, Fuel, 121, 2014. Crossref
-
Hou Shuhai, Schmidt David P., Adaptive collision meshing and satellite droplet formation in spray simulations, International Journal of Multiphase Flow, 32, 8, 2006. Crossref
-
Lee Seong Hyuk, Ko Gwon Hyun, Ryou Hong Sun, A numerical study on the spray-to-spray impingement system, KSME International Journal, 16, 2, 2002. Crossref
-
Ashgriz Nasser, Brocklehurst William, Talley Douglas, Mixing Mechanisms in a Pair of Impinging Jets, Journal of Propulsion and Power, 17, 3, 2001. Crossref
-
Foissac A., Malet J., Mimouni S., Ruyer P., Feuillebois F., Simonin O., Eulerian Simulation of Interacting PWR Sprays Including Droplet Collisions, Nuclear Technology, 181, 1, 2013. Crossref
-
Zhang Zhenyu, Zhang Peng, Cross-impingement and combustion of sprays in high-pressure chamber and opposed-piston compression ignition engine, Applied Thermal Engineering, 144, 2018. Crossref
-
Ashgriz N., Impinging Jet Atomization, in Handbook of Atomization and Sprays, 2011. Crossref
-
Shlegel N.E., Tkachenko P.P., Strizhak P.A., Influence of viscosity, surface and interfacial tensions on the liquid droplet collisions, Chemical Engineering Science, 220, 2020. Crossref