Publication de 8 numéros par an
ISSN Imprimer: 1065-5131
ISSN En ligne: 1563-5074
Indexed in
SUBCOOLED JET IMPINGEMENT BOILING ENHANCED BY POROUS SURFACE WITH MICROCOLUMN ARRAY
RÉSUMÉ
Thermal management of electronic devices has been a key problem, especially as the heat flux of these devices increases continuously. Jet impingement boiling is an effective cooling technique for electronic devices, the enhancement of which still remains an urgent requirement. In particular, lowering the wall temperature and increasing the critical heat flux (CHF) are known to enhance cooling performance. In this paper, we propose a new jet impingement cooling method: applying the porous surface with a microcolumn array. This special porous structure is fabricated via the template method by using nano/microparticles. The enhancements of the jet impingement cooling performance with deionized water on the porous surfaces are investigated. The CHF and the heat transfer coefficient (HTC) increase with decreasing distance between the microcolumns. A high CHF of 548 W/cm2 is attained at the wall superheat of 34.5°C, and 36% enhancement is gained compared with the smooth porous surface. Meanwhile, a maximum HTC of 8.63 W/(cm2K) is achieved, two and a half times as large as that on the smooth copper surface. To understand the underlying mechanism, we analyze the bubble diameter during the growth time and the bubble departure time. On the porous surface with microcolumn array, the bubble grows and departs faster due to the extra contact line and microlayer area. The thermal resistance at the edge of the microlayer can be extremely small, and the evaporation of the thin film accelerates the growth and departure of the bubble.
-
Agarwal, C., Kumar, R., Gupta, A., and Chatterjee, B., Maximum Surface Heat Flux during Jet Impingement Quenching of Vertical Hot Surface, J. Enhanced Heat Transf, vol. 22, pp. 199-219,2015.
-
Ajaev, V.S. and Kabov, O.A., Heat and Mass Transfer near Contact Lines on Heated Surfaces, Int. J. Heat Mass Transf., vol. 108, pp. 918-932,2017.
-
Bar-Cohen, A., Maurer, J.J., and Sivananthan, A., Near-Junction Microfluidic Cooling for Wide Bandgap Devices, MRS Adv., vol. 1, no. 2, pp. 181-195,2016.
-
Browne, E.A., Michna, G.J., Jensen, M.K., and Peles, Y., Microjet Array Single-Phase and Flow Boiling Heat Transfer with R134a, Int. J. Heat Mass Transf., vol. 53, nos. 23-24, pp. 5027-5034,2010.
-
Byon, C., Choi, S., and Kim, S.J., Critical Heat Flux of Bi-Porous Sintered Copper Coatings in FC-72, Int. J. Heat Mass Transf., vol. 65, pp. 655-661,2013.
-
Ebadian, M.A. and Lin, C.X., A Review of High-Heat-Flux Heat Removal Technologies, J. Heat Transf., vol. 133, no. 11,2011.
-
Gatapova, E.Y., Kabov, O.A., and Ajaev, V.S., Evaporation and Interface Dynamics in Microregion on Heated Substrate of Non-Uniform Wettability, Int. J. Heat Mass Transf., vol. 142, p. 118355,2019.
-
Gheitaghy, A., Saffari, H., Ghasimi, D., and Ghasemi, A., Effect of Electrolyte Temperature on Porous Electrodeposited Copper for Pool Boiling Enhancement, Appl. Therm.. Eng., vol. 113, pp. 1097-1106, 2017.
-
Hong, F., Zhang, C., He, W., Cheng, P., and Chen, G., Confined Jet Array Impingement Boiling of Subcooled Aqueous Ethylene Glycol Solution, Int. Commun. Heat Mass Transf., vol. 56, pp. 165-173,2014.
-
Han, X., Joshi, Y., and Fedorov, A., Flow Boiling of Water at Sub-Atmospheric Pressure in Staggered Micro Pin-Fin Heat Sink, 2016 15th IEEE Intersociety Conf. on Thermal and Thermomechanical Phenomena in Electronic Systems (ITherm), Las Vegas, NV, 2016.
-
Hashim, M., Viswanathan, N.N., and Sridharan, A., Wetting Front Studies on Heated Plate with Orthogonal Water Jet Impingement, J. Enhanced Heat Transf, vol. 27, no. 6, pp. 577-593,2020.
-
Hwang, G.S. and Kaviany, M., Critical Heat Flux in Thin, Uniform Particle Coatings, Int. J. Heat Mass Transf., vol. 49, nos. 5-6, pp. 844-849,2006.
-
Joshi, S.N. and Dede, E.M., Two-Phase Jet Impingement Cooling for High Heat Flux Wide Band-Gap Devices Using Multi-Scale Porous Surfaces, Appl. Therm. Eng., vol. 110, pp. 10-17,2017.
-
Joshi, S.N. and Dede, E.M., Effect of Sub-Cooling on Performance of a Multi-Jet Two Phase Cooler with Multi-Scale Porous Surfaces, Int. J. Therm. Sci., vol. 87, pp. 110-120,2015.
-
Karchevsky, A.L., Marchuk, I.V., and Kabov, O.A., Calculation of the Heat Flux near the Liquid-Gas-Solid Contact Line, Appl. Math. Modell, vol. 40, no. 2, pp. 1029-1037,2016.
-
Kim, J., Review of Nucleate Pool Boiling Bubble Heat Transfer Mechanisms, Int. J. Multiphase Flow, vol. 35, no. 12, pp. 1067-1076,2009.
-
Krishnamurthy, S. and Peles, Y., Flow Boiling of Water in a Circular Staggered Micro-Pin Fin Heat Sink, Int. J. Heat Mass Transf., vol. 51, nos. 5-6, pp. 1349-1364,2008.
-
Kunkelmann, C., Ibrahem, K., Schweizer, N., Herbert, S., Stephan, P., and Gambaryan-Roisman, T., The Effect of Three-Phase Contact Line Speed on Local Evaporative Heat Transfer: Experimental and Numerical Investigations, Int. J. Heat Mass Transf., vol. 55, nos. 7-8, pp. 1896-1904,2012.
-
Lee, S.G., Kaviany, M., Kim, C.J., and Lee, J., Quasi-Steady Front in Quench Subcooled-Jet Impingement Boiling: Experiment and Analysis, Int. J. Heat Mass Transf., vol. 113, pp. 622-634,2017.
-
Li, C. and Peterson, G., Geometric Effects on Critical Heat Flux on Horizontal Microporous Coatings, J. Thermophys Heat Transf., vol. 24, no. 3, pp. 449-455,2010.
-
Luo, X., Hu, R., Liu, S., and Wang, K., Heat and Fluid Flow in High-Power LED Packaging and Applications, Prog;. Energy Combust. Sci., vol. 56, pp. 1-32,2016.
-
Manno, M., Yang, B., and Bar-Cohen, A., Near-Junction "Hot Spot" Suppression with Integral SiC Micro-contact TEC, Int. J. Heat Mass Transf., vol. 115, pp. 530-536,2017.
-
Mikic, B., Rohsenow, W., and Griffith, P., On Bubble Growth Rates, Int. J. Heat Mass Transf., vol. 13, no. 4, pp. 657-666,1970.
-
Rau, M.J. and Garimella, S.V., Confined Jet Impingement with Boiling on a Variety of Enhanced Surfaces, J. Heat Transf, vol. 136, no. 10,2014.
-
Rayleigh, L., Pressure due to Collapse of Bubbles, Phil. Mag, vol, 34, no. 94,1917.
-
Sodtke, C., Kern, J., Schweizer, N., and Stephan, P., High Resolution Measurements of Wall Temperature Distribution underneath a Single Vapour Bubble under Low Gravity Conditions, Int. J. Heat Mass Transf, vol. 49, nos. 5-6, pp. 1100-1106,2006.
-
Sun, B. and Liu, H., Flow and Heat Transfer Characteristics of Nanofluids in a Liquid-Cooled CPU Heat Radiator, Appl. Therm. Eng., vol. 115, pp. 435-443,2017.
-
Tang, Y., Zeng, J., Zhang, S., Chen, C., and Chen, J., Effect of Structural Parameters on Pool Boiling Heat Transfer for Porous Interconnected Microchannel Nets, Int. J. Heat Mass Transf., vol. 93, pp. 906-917, 2016.
-
Thiagarajan, S.J., Narumanchi, S., King, C., Wang, W., and Yang, R., Enhancement of Heat Transfer with Pool and Spray Impingement Boiling on Microporous and Nanowire Surface Coatings, 2010 14th Int. Heat Transf. Conf, pp. 819-828,2010.
-
Timm, W., Weinzierl, K., and Leipertz, A., Heat Transfer in Subcooled Jet Impingement Boiling at High Wall Temperatures, Int. J. Heat Mass Transf., vol. 46, no. 8, pp. 1385-1393,2003.
-
Truong, J.G. and Wayner, P.C., Jr., Effects of Capillary and van der Waals Dispersion Forces on the Equilibrium Profile of a Wetting Liquid: Theory and Experiment, J. Chem. Phys., vol. 87, no. 7, pp. 4180-4188, 1987.
-
Wang, X.J., Liu, Z.H., and Li, Y.Y., Experimental Study of Heat Transfer Characteristics of High-Velocity Small Slot Jet Impingement Boiling on Nanoscale Modification Surfaces, Int. J. Heat Mass Transf, vol. 103, pp. 1042-1052,2016.
-
Yoon, K., Kim, S., Heo, J., Kwak, N., and Kim, C.H., Analysis on Heat Dissipation Characteristics of a Tile-Type Digital Transmitter/Receiver Module, J. Korea Inst. Military Sci. Technol, vol. 22, no. 2, pp. 249-254,2019.
-
Zhang, Y., Wei, J., and Guo, D., Enhancement of Flow-Jet Combined Boiling Heat Transfer of FC-72 over Micro-Pin-Finned Surfaces, J. Enhanced Heat Transf., vol. 19, no. 6, pp. 489-503,2012.
-
Zhao, Z., Peles, Y., and Jensen, M.K., Water Jet Impingement Boiling from Structured-Porous Surfaces, Int. J. Heat Mass Transf, vol. 63, pp. 445-453,2013.
-
Zhao, Z., Peles, Y., and Jensen, M.K., Microjet Impingement Boiling on a Structured-Porous Surface, ASME 2012 3rd Int. Conf. Micro/Nanoscale Heat and Mass Transf., American Society of Mechanical Engineers Digital Collection, pp. 411-417,2012.
-
Ponomarev K.O., Kuznetsov G.V., Orlova E.G., Feoktistov D.V., Thermosyphon-assisted cooling system working in the moderate heat flux range, Thermal Science and Engineering Progress, 32, 2022. Crossref
-
Guo Yuming , Luo Zhengyuan, Zhao Liang, ENHANCED FLOW BOILING OF OPEN MINI-CHANNEL AND JET IMPINGEMENT COOLING SCHEME BY SEPARATING LIQUID-VAPOR PATHWAYS , Journal of Enhanced Heat Transfer, 29, 5, 2022. Crossref
-
Guo Yuming , Fan Liang-Liang , Zhao Liang, HEAT TRANSFER ENHANCEMENT OF A NEW SINGLE-PHASE HYBRID COOLING SCHEME OF MICROCHANNEL AND MICROJET IMPINGEMENT , Journal of Enhanced Heat Transfer, 29, 4, 2022. Crossref
-
Cheng Lixin, Chai Lei, Guo Zhixiong, THERMAL ENERGY, PROCESS, AND TRANSPORT INTENSIFICATION - A BRIEF REVIEW OF LITERATURE IN 2021 AND PROSPECTS , Heat Transfer Research, 53, 18, 2022. Crossref
-
Burmasheva N. V., Prosviryakov E. Yu., Inhomogeneous Nusselt–Couette–Poiseuille Flow, Theoretical Foundations of Chemical Engineering, 56, 5, 2022. Crossref