Publication de 12 numéros par an
ISSN Imprimer: 1044-5110
ISSN En ligne: 1936-2684
Indexed in
INFLUENCE OF FUEL PROPERTIES ON THE DIESEL INJECTION PROCESS IN NONVAPORIZING CONDITIONS
RÉSUMÉ
This paper presents an experimental investigation of the influence of fuel density, viscosity, and surface tension on the diesel injection process (spray development and droplet size distribution) in non-vaporizing conditions. The spray development was captured in a pressurized vessel with a high-speed camera in order to obtain the penetration length and the spray angle. The droplet size distributions were measured by laser diffraction. A fuel matrix of eight fuels was designed including independent variations of fuel density, viscosity, and surface tension. Experimental conditions, such as injection pressure and air density, were varied according to current diesel engine conditions. The analysis focuses mainly on the quasi-stationary phase of the injection event. Results indicate that viscosity and to a lesser extent fuel density affect the spray characteristics. Increasing fuel density and viscosity by, respectively, 100 kg/m3 and 6.5 mm2/s induces longer spray tip penetration (up to 7%) with a narrower spray angle (drop of up to 3 deg) in quasi-stationary conditions. An increase in the Sauter mean diameter (up to 23% or 3 µm) was also observed. An increase in surface tension from 18 to 30 mN/m did not induce any significant modifications in the droplet size or in the spray development. Correlations, some of which are based on existing ones, are proposed to estimate the spray cone angle, the spray tip penetration, the SMD (Sauter mean diameter) and the drop size distribution considering the experimental conditions and the fuel properties.
-
Tinprabath P., Hespel C., Chanchaona S., Foucher F., Influence of biodiesel and diesel fuel blends on the injection rate under cold conditions, Fuel, 144, 2015. Crossref
-
Payri F., Payri R., Bardi M., Carreres M., Engine combustion network: Influence of the gas properties on the spray penetration and spreading angle, Experimental Thermal and Fluid Science, 53, 2014. Crossref
-
Tetrault Pascal, Plamondon Etienne, Breuze Matthieu, Hespel Camille, Mounaïm-Rousselle Christine, Seers Patrice, Fuel Spray Tip Penetration Model for Double Injection Strategy, SAE Technical Paper Series, 1, 2015. Crossref
-
Han Kimberly, Woghiren Osakpolor E., Priefer Ronny, Surface tension examination of various liquid oral, nasal, and ophthalmic dosage forms, Chemistry Central Journal, 10, 1, 2016. Crossref
-
Zhang Yu, Kumar Praveen, Traver Michael, Cleary David, Conventional and Low Temperature Combustion Using Naphtha Fuels in a Multi-Cylinder Heavy-Duty Diesel Engine, SAE International Journal of Engines, 9, 2, 2016. Crossref
-
Tinprabath P., Hespel C., Chanchaona S., Foucher F., Impact of cold conditions on diesel injection processes of biodiesel blends, Renewable Energy, 96, 2016. Crossref
-
Payri R., Salvador F.J., Carreres M., De la Morena J., Fuel temperature influence on the performance of a last generation common-rail diesel ballistic injector. Part II: 1D model development, validation and analysis, Energy Conversion and Management, 114, 2016. Crossref
-
Salvador F.J., Gimeno J., Carreres M., Crialesi-Esposito M., Fuel temperature influence on the performance of a last generation common-rail diesel ballistic injector. Part I: Experimental mass flow rate measurements and discussion, Energy Conversion and Management, 114, 2016. Crossref
-
Salvador F.J., Gimeno J., Carreres M., Crialesi-Esposito M., Experimental assessment of the fuel heating and the validity of the assumption of adiabatic flow through the internal orifices of a diesel injector, Fuel, 188, 2017. Crossref
-
Ewphun Pop-Paul, Vo Chau Tan, Srichai Prathan, Charoenphonphanich Chinda, Sato Susumu, Kosaka Hidenori, Combustion characteristics of hydrotreated vegetable oil – diesel blend under EGR and supercharged conditions, International Journal of Automotive Technology, 18, 4, 2017. Crossref
-
Brulatout Jonathan, Garnier François, Mounaïm-Rousselle Christine, Seers Patrice, Calibration strategy of diesel-fuel spray atomization models using a design of experiment method, International Journal of Engine Research, 17, 7, 2016. Crossref
-
Vo C., Charoenphonphanich C., Karin P., Susumu S., Hidenori K., Effects of variable O2 concentrations and injection pressures on the combustion and emissions characteristics of the petro-diesel and hydrotreated vegetable oil-based fuels under the simulated diesel engine condition, Journal of the Energy Institute, 91, 6, 2018. Crossref
-
Tilli Aki, Hulkkonen Tuomo, Kaario Ossi, Larmi Martti, Sarjovaara Teemu, Lehto Kalle, Biofuel blend late post-injection effects on oil dilution and diesel oxidation catalyst performance, International Journal of Engine Research, 19, 9, 2018. Crossref
-
Hu Nao, Yang Jianguo, Zhou Peilin, Sensitivity analysis of the dynamic response of an electronic fuel injector regarding fuel properties and operating conditions, Applied Thermal Engineering, 129, 2018. Crossref
-
Mezhericher Maksim, Razorenov Nikolay, Mazor Gedalya, Ju Yiguang, Stone Howard A., Submicron aerosols of liquid fuels: Method of production, experimental characterization and a semi-empirical model, Applied Energy, 235, 2019. Crossref
-
Dizayi Buland, Li Hu, Tomlin Alison S., Cunliffe Adrian, Evaluation of the Effect of Fuel Properties on the Fuel Spray and Jet Characteristics in a HGV DI Diesel Engine Operated by Used Cooking Oils, Applied Mechanics and Materials, 694, 2014. Crossref
-
Nilaphai O., Hespel C., Chanchaona S., Mounaïm-Rousselle C., Spray and combustion characterizations of ABE/Dodecane blend in comparison to alcohol/Dodecane blends at high-pressure and high-temperature conditions, Fuel, 225, 2018. Crossref
-
Ludwig Wojciech, Zając Daniel, Ligus Grzegorz, Korman Piotr, Analysis of pneumatic nozzle operation with the stochastic Euler-Lagrange model, Chemical Engineering Science, 197, 2019. Crossref
-
Zhang Yu, Voice Alexander, Pei Yuanjiang, Traver Michael, Cleary David, A Computational Investigation of Fuel Chemical and Physical Properties Effects on Gasoline Compression Ignition in a Heavy-Duty Diesel Engine, Journal of Energy Resources Technology, 140, 10, 2018. Crossref
-
Zhang Yu, Voice Alexander, Tzanetakis Tom, Traver Michael, Cleary David, An Evaluation of Combustion and Emissions Performance With Low Cetane Naphtha Fuels in a Multicylinder Heavy-Duty Diesel Engine, Journal of Engineering for Gas Turbines and Power, 138, 10, 2016. Crossref
-
Kontses A., Dimaratos A., Keramidas C., Williams R., Hamje H., Ntziachristos L., Samaras Z., Effects of fuel properties on particulate emissions of diesel cars equipped with diesel particulate filters, Fuel, 255, 2019. Crossref
-
Saravanan C.G., Raj Kiran K., Vikneswaran M., Rajakrishnamoorthy P., Yadav S. Prasanna Raj, Impact of fuel injection pressure on the engine characteristics of CRDI engine powered by pine oil biodiesel blend, Fuel, 264, 2020. Crossref
-
Cao Tianyi, He Zhixia, Si Zhanbo, EL-Seesy Ahmed I., Guan Wei, Zhou Han, Wang Qian, Optical experimental study on cavitation development with different patterns in diesel injector nozzles at different fuel temperatures, Experiments in Fluids, 61, 8, 2020. Crossref
-
Xuan Duy Nguyen Ho, Xuan Khoa Nguyen, Hieu Le Trong, Lim Ocktaeck, A study on the Spray development under Non- Vaporizing condition using Gasoline-Biodiesel blend in Constant Volume Combustion Chamber, 2020 5th International Conference on Smart and Sustainable Technologies (SpliTech), 2020. Crossref
-
Ewphun Pop-Paul, Nagasawa Tsuyoshi, Kosaka Hidenori, Sato Susumu, Investigation on Effect of Offset Orifice Nozzle on Diesel Combustion Characteristics, SAE Technical Paper Series, 1, 2020. Crossref
-
Safiullah , Nishida Keiya, Ogata Youichi, Evaporation and mixture formation characteristics of diesel spray under various nozzle hole size and injection pressure condition employing similar injection rate profile, International Communications in Heat and Mass Transfer, 123, 2021. Crossref
-
Schwarz Philip, Blume Martin, Weiß Lukas, Wensing Michael, Skoda Romuald, 3D simulation of a ballistic direct injection cycle for the assessment of fuel property effects on cavitating injector internal flow dynamics and primary breakup, Fuel, 308, 2022. Crossref
-
Ismael Mhadi A., A. Aziz A. Rashid, Mohammed Salah E., Zainal A Ezrann Z., Baharom Masri B., Hagos Ftwi Yohaness, Macroscopic and microscopic spray structure of water-in-diesel emulsions, Energy, 223, 2021. Crossref
-
Sa Bowen, Markov Vladimir, Liu Ying, Kamaltdinov Vyacheslav, Qiao Wenpei, Numerical investigation of the effect of multi-walled carbon nanotube additive on nozzle flow and spray behaviors of diesel fuel, Fuel, 290, 2021. Crossref
-
Suraj C.K., Sudarshan G., Anand K., Sundararajan T., Effects of autooxidation on the fuel spray characteristics of Karanja biodiesel, Biomass and Bioenergy, 149, 2021. Crossref
-
da Costa Roberto Berlini Rodrigues, Coronado Christian J.R., Hernández Juan J., Malaquias Augusto Cesar Teixeira, Flores Luiz Fernando Valadão, de Carvalho João A., Experimental assessment of power generation using a compression ignition engine fueled by farnesane – A renewable diesel from sugarcane, Energy, 233, 2021. Crossref
-
Sa Bowen, Markov V.A., Liu Ying, Kamaltdinov V.G., Qiao Wenpei, Investigation of Properties of Diesel Fuel and Carbon Nanotubes Mixture and Characteristics of its Atomization, Proceedings of Higher Educational Institutions. Маchine Building, 9 (738), 2021. Crossref
-
Duy Nguyen Ho Xuan, Lim Ocktaeck, A study on spray characteristic of gasoline-biodiesel blended under gci engines condition performed on constant volume combustion chamber system, Journal of Mechanical Science and Technology, 36, 4, 2022. Crossref
-
Payri R., Salvador F.J., Carreres M., Belmar-Gil M., Thermal effects on the diesel injector performance through adiabatic 1D modelling. Part II: Model validation, results of the simulations and discussion, Fuel, 260, 2020. Crossref
-
Kim Jaeheun, Lee Jinwoo, Kim Kihyun, Numerical study on the effects of fuel viscosity and density on the injection rate performance of a solenoid diesel injector based on AMESim, Fuel, 256, 2019. Crossref
-
Hadhoum Loubna, Awad Sary, Burnens Gaëtan, Paraschiv Maria, Loubar Khaled, Tazerout Mohand, Experimental Investigation on the Supercritical Rapeseed Methanolysis for Biofuel Production: Effects of the Operating Conditions on the Bio-oil Viscosity, BioEnergy Research, 15, 2, 2022. Crossref
-
Dumitrescu Cosmin E., Polonowski Christopher J., Fisher Brian T., Lilik Gregory K., Mueller Charles J., Diesel Fuel Property Effects on In-Cylinder Liquid Penetration Length: Impact on Smoke Emissions and Equivalence Ratio Estimates at the Flame Lift-Off Length, Energy & Fuels, 29, 11, 2015. Crossref
-
Butmarasri Athiwat, Nagasawa Tsuyoshi, Kosaka Hidenori, Effects of Diesel Injector Nozzle Hole Deposit on Fuel Injection and Spray Characteristics, International Journal of Automotive Engineering, 13, 4, 2022. Crossref